Thingiverse
Pi Zero Camera Case & Stand update
von DrSnake
51
Downloads
34
Likes
0
Makes
Like in the source project, there is multiple parts for this item : stand, hat, board side and cam side.
The stand is the same as the [remixed project](http://www.thingiverse.com/thing:1592151) from [andyleer](http://www.thingiverse.com/andyleer/about).
I added plots (screw holes) to stick pizero board and camera in place.
I modified cam hole cause the original one didn't fit on my printed item.
I added a hat cause my printer sometime blend edges on little item.
I increased the thickness of both sides because they moved too much in the base.
Used with pizero v1.3 and pi cam rev 1.3.
The stand is the same as the [remixed project](http://www.thingiverse.com/thing:1592151) from [andyleer](http://www.thingiverse.com/andyleer/about).
I added plots (screw holes) to stick pizero board and camera in place.
I modified cam hole cause the original one didn't fit on my printed item.
I added a hat cause my printer sometime blend edges on little item.
I increased the thickness of both sides because they moved too much in the base.
Used with pizero v1.3 and pi cam rev 1.3.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
