Picatinny Rail Riser

I'm sure you have seen the dozens of risers out there, so what makes this one special? Well, I made it for one and I'd like to think I am pretty awesome. I guess that is up for you to decide...psyche! You don't own me!

Down to it then. This uses three 25mm M4 screws. You need to print this at an angle so the layers go across both directions of stress.

I personally made one out of PLA with 50% cubic infill as a prototype, planning on making a nylon or PC one later. I didn't even anneal it, but it has held a zero for quite some time. It worked for me.

Happy printing.