Thingiverse
Pickleball Key Chain
von SteMac
105
Downloads
79
Likes
3
Makes
Pickleball paddle & pickleball paddle with ball key chains.
The paddle is 4mm high, if you pause your print at this hight or just below then you can change filament colour for the pickle ball.
Nb: The picture is of one i modified to have club initials on, the ones in the file are plain.
02/03/2019: Added Pickleball ball so you can place it where you want it on the paddle.
The paddle is 4mm high, if you pause your print at this hight or just below then you can change filament colour for the pickle ball.
Nb: The picture is of one i modified to have club initials on, the ones in the file are plain.
02/03/2019: Added Pickleball ball so you can place it where you want it on the paddle.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!