Thingiverse
Pickup Select Switch Knob
by ottaross
71
Downloads
61
Likes
0
Makes
A replacement knob for an electric guitar pickup select switch. This was for my strat copy, but I suspect it will work for a variety of pickups switches.
It prints very quickly and seemed to work well, once I got the hole sizing right. Hope it works for you. Good news is that at less than a gram and printing very quickly, there is not much time to be wasted in finding out.
The switch I used it on has approx a 1.3mm x 7mm rectangular cross section.
It prints very quickly and seemed to work well, once I got the hole sizing right. Hope it works for you. Good news is that at less than a gram and printing very quickly, there is not much time to be wasted in finding out.
The switch I used it on has approx a 1.3mm x 7mm rectangular cross section.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!