Thingiverse
Piclop fixed laser holder
door iwant3d
43
Downloads
66
Likes
0
Makes
I decided to design this because I was tired of constantly adjusting the laser positions.
It has an angle of 20.48 degrees, I calculated it using my fading GCSE maths.I found once these were printed I had to adjust the distance to the camera and modify the values in freelss but they work pretty well and reliably.
This is also symmetrical so the one part works on both sides.
It has an angle of 20.48 degrees, I calculated it using my fading GCSE maths.I found once these were printed I had to adjust the distance to the camera and modify the values in freelss but they work pretty well and reliably.
This is also symmetrical so the one part works on both sides.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
