Thingiverse
Pico - Pi Zero Oled Case (rev 2)
von PicoProject
41
Downloads
35
Likes
0
Makes
Very compact 3D printed case designed to works with:
Raspberry Pi Zero
OLED hat with 3 buttons
Pi Zero USB adapter board. (case variant with and wihout USB board)
Supports 3D printed Pico mounting bracket
Requires Nylon m2.5 stand-off
Requires M2.5 screws (6-8mm depending of setup)
Other project notes:
- Although perfectly functional, switches cutouts are not fully lined up with PCB switches in order to maintain better visual aesthetics.
- The compact sized required a tight fit of all elements. All source Fusion 360 files are provided in case minute adjustments are needed.
- Recommend putting SD card in after putting Pi Zero in case.
I hope you will enjoy it!
https://pico-project.com
Raspberry Pi Zero
OLED hat with 3 buttons
Pi Zero USB adapter board. (case variant with and wihout USB board)
Supports 3D printed Pico mounting bracket
Requires Nylon m2.5 stand-off
Requires M2.5 screws (6-8mm depending of setup)
Other project notes:
- Although perfectly functional, switches cutouts are not fully lined up with PCB switches in order to maintain better visual aesthetics.
- The compact sized required a tight fit of all elements. All source Fusion 360 files are provided in case minute adjustments are needed.
- Recommend putting SD card in after putting Pi Zero in case.
I hope you will enjoy it!
https://pico-project.com
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
