Thingiverse
Picture corner bracket
von timthefinn
3
Downloads
2
Likes
0
Makes
Designed these to hold up posters we had in our office that were on foam board and then stuck to the wall with double sticky foam pads. The front surface of the pictures were sitting about 5/16" from the wall, so designed these up so we could secure the corners with a finishing nail.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
