Thingiverse
Picture Frame Back Tabs
by JP1
46
Downloads
54
Likes
0
Makes
These are picture frame tabs to hold the back board of the frame in place.
The top side surface of the tabs has a bevel around the screw hole so that the screw can sit flush with the surface and not scratch your wall. As such be sure the bed side of the print goes towards the picture frame.
Cura scaled and oriented for printing it is recommended that you use thermally calibrated filament for best results and fit.
I recommend using one of these clip sets for calibration.
https://www.thingiverse.com/thing:2502677
https://www.thingiverse.com/thing:1037301
The top side surface of the tabs has a bevel around the screw hole so that the screw can sit flush with the surface and not scratch your wall. As such be sure the bed side of the print goes towards the picture frame.
Cura scaled and oriented for printing it is recommended that you use thermally calibrated filament for best results and fit.
I recommend using one of these clip sets for calibration.
https://www.thingiverse.com/thing:2502677
https://www.thingiverse.com/thing:1037301
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!