Thingiverse
Picture frame flush mount
von Greene448
2
Downloads
1
Likes
0
Makes
Redisgned this, it was too difficult to print the previous model.
Measures 25.4mm in diameter and has a 3mm countersunk hole in the center to mount to frame.
No support needed
If using one of these, it will need to be centered on the frame well.
For more than one, they will need to be perfectly level
Measures 25.4mm in diameter and has a 3mm countersunk hole in the center to mount to frame.
No support needed
If using one of these, it will need to be centered on the frame well.
For more than one, they will need to be perfectly level
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!