Thingiverse
Piezo20 - Bowden adapter
by AlainMouette
16
Downloads
9
Likes
0
Makes
This is just a Bowden adapter for the traditional **Precision Piezo** sensor PIEZO20 at https://www.precisionpiezo.co.uk/hotend-piezo-sensors
I was amazed to discover that such a part was not available!
I redesigned the top part to allow the fixing of a Bowden connector, the neck is 1.5mm longer to allow monting on my HEVO.
WARNING: the part does NOT have an internal thread, an _NTP 1/8"_ tap is required to make this part, this is not an expensive tool. My old printer would not be precise enough to make that anyway.
Be very carefull with this operation, you could easely break the printed part, move forward and backwards many many times and advance slowly. The tab only goes in about 7mm as this is a conical thread.
Printing should be uneventfull. I used 0.2mm layers but you can use whatever gives you best layer bonding.
I was amazed to discover that such a part was not available!
I redesigned the top part to allow the fixing of a Bowden connector, the neck is 1.5mm longer to allow monting on my HEVO.
WARNING: the part does NOT have an internal thread, an _NTP 1/8"_ tap is required to make this part, this is not an expensive tool. My old printer would not be precise enough to make that anyway.
Be very carefull with this operation, you could easely break the printed part, move forward and backwards many many times and advance slowly. The tab only goes in about 7mm as this is a conical thread.
Printing should be uneventfull. I used 0.2mm layers but you can use whatever gives you best layer bonding.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!