Pikachu earrings - drop shape silhouettes

This is a set of earrings that I created using Illustrator and 3D software for depth extrusion. It's fast and fairly easy to print. Earring height: 45mm The overall shape is a water drop, and inside we see Pikachu in a quick attack / jump / running pose. The hole is supposed to be 2.5mm in diameter, but it often comes out a bit smaller in real life - which can be countered by increasing hole expansion in your slicer. The print doesn't require any supports and is fairly easy - but here are my recommendations:Go SLOW. Since there's not a lot of surface for first layer adhesion, there's an inherent big risk of the earrings falling off the plate if you print fast.Use a 3mm brim for better layer adhesion.Do NOT use ironing on the top layer. Everytime I did that in my tests, it resulted in the print coming off the plate.Turn off all fans for better layer adhesion.Print at 0.1mm for a very crisp result, or print at 0.2mm in less than 15 minutes even at slow speeds, for both ea