Thingiverse
Pikachu Lithophane
door abrokadabra
66
Downloads
42
Likes
0
Makes
Print at 0.3mm layer height. (I think I scaled the Z to 1.3 in cura as well.) The end result was 4-5 layers.
I used a heat gun to both curve the lithophane prior to tracing/cutting, and to soften it during the wedging process.
I used a heat gun to both curve the lithophane prior to tracing/cutting, and to soften it during the wedging process.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!