Thingiverse
Pikachu - Pumpkin Remix (Patrickart)
door Shorens
14
Downloads
23
Likes
0
Makes
All credit for the Pikachu model goes to Patrickart!
All I did was add the pumpkin which I sculpted in Blender as well as re-scaling, optimizing and cleaning up the finished model for printing.
This print will require minimal supports to print properly.
I have also only tested slicing in Cura 4.9.1 so your experience may vary. This is the first model I have put together specifically for 3D printing so any constructive criticism is appreciated.
All I did was add the pumpkin which I sculpted in Blender as well as re-scaling, optimizing and cleaning up the finished model for printing.
This print will require minimal supports to print properly.
I have also only tested slicing in Cura 4.9.1 so your experience may vary. This is the first model I have put together specifically for 3D printing so any constructive criticism is appreciated.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
