Thingiverse
Pill Holder Key Chain
von _NG_
43
Downloads
33
Likes
0
Makes
Vitamin Pill Holder. I made it to hold two large vitamins, but it could hold a lot more of something smaller, like ibuprofen.
I have included the STEP file in case you need to adjust the thread offsets for your printer. I didn't need to make any adjustments, but not all printers are as accurate.
I printed using black ABS, 100% infill, 0.16mm layers.
-the bottom should be printed upside down without supports. a brim would be a good idea to keep it from moving.
-the top should be printed right side up. i used supports, but it probably doesn't need them.
-you could use PLA, but just be aware that it is much more brittle than ABS. The ones i printed in PLA would usually break at the key chain after a few weeks.
I have included the STEP file in case you need to adjust the thread offsets for your printer. I didn't need to make any adjustments, but not all printers are as accurate.
I printed using black ABS, 100% infill, 0.16mm layers.
-the bottom should be printed upside down without supports. a brim would be a good idea to keep it from moving.
-the top should be printed right side up. i used supports, but it probably doesn't need them.
-you could use PLA, but just be aware that it is much more brittle than ABS. The ones i printed in PLA would usually break at the key chain after a few weeks.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
