Slicer Discord
Pill Packer 100x – Modelo 3D imprimible de Thingiverse Thingiverse

Pill Packer 100x

por adolist
320 Descargas
252 Likes
0 Makes
Ver Modelo
Introducing the Pill Packer 100x! Fill 100 "00" (750mg) and/or "0" (500mg) vegetable capsules at a time using whatever powder supplement you desire.

There are only three functioning parts: the pill holder, packer, and platform

Place the holder on top of the platform making sure is slides onto the cylinder and latches onto the notch. Then place a rubber band over the end of the notched side, if you plan on moving it around or packing them fairly hard. Place the capsules open end opposite the platform into the desired amount of slots then poor your powdered material over the capsules. Take a postcard, credit card or simply a piece of paper and wipe the excess off the top making sure to fill each hole as you move the card around. Take your packer line it up with each pill and press down firmly until the packer starts to sink down into the holes, pack to desired depth using small taps of the hand to press the powder down firmly.

Taking the pills out is simple, remove the rubber b
Fuente
Thingiverse
Lo que necesitas para imprimir: Principiante Baja confianza
Pieza única
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 0/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
PLA
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección