Thingiverse
Pin Board
door Taylor-eOS
0
Downloads
0
Likes
0
Makes
A row of holes to place Dupont males into to connect a chip with open pins without soldering.
This one is dimensioned for 2mm open pins on a HT-RA62 clone. But you can change that in the Python file.
The first layer is solid because printing these small shapes is rather challenging. Poke through it with a needle or pin. Print at very low speeds.
This one is dimensioned for 2mm open pins on a HT-RA62 clone. But you can change that in the Python file.
The first layer is solid because printing these small shapes is rather challenging. Poke through it with a needle or pin. Print at very low speeds.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!