MakerWorld
Other House Models
Model downloaden
Pin Magnet Holder
5
Downloads
1
Likes
4
Makes
Fits a 5.5mm-6mm magnet, the 6mm magnets I used can be press fit. I would still recommend using glue even if you can press fit since the magnets will have a lot of sticking force. Push the pin through the hole on the side, now you can hang your pins on your fridge/cabinets.
DinnerRoll publiceert ook op
7 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
