Thingiverse
Pinball Bumpers
von shellant
20
Downloads
18
Likes
0
Makes
Originally designed by "schmice October 20, 2015"
I made the centre of the bigger disk a little smaller so that the claws will hold tight
I also made a version where there are no claws as I found that the 3d printing material (PETG) was a bit too thin and breaking.
MY remake was to build a lip on the bigger disk so that there are no claws and the top cap will just press onto the bottom disk.
I made the centre of the bigger disk a little smaller so that the claws will hold tight
I also made a version where there are no claws as I found that the 3d printing material (PETG) was a bit too thin and breaking.
MY remake was to build a lip on the bigger disk so that there are no claws and the top cap will just press onto the bottom disk.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
