Thingiverse
Pinball Plunger
von ewr2san
125
Downloads
76
Likes
2
Makes
Parts to make a pinball plunger for a virtual Pinball.
Video of it:
https://www.youtube.com/watch?v=QyE_S92_xhk
https://youtu.be/iLL0WrlGMDI
It makes a satisfying clank when assembled and installed.
Requires the purchase of 2-3 springs, a switch, and a 1/2inch rod.
In my build I used Qty 2 of 3" length springs with an approx 8 pound force rating. The Outer diameter of the springs is approx 0.7inch. One of the springs gets cut in half.
The switch is a "V7-2B17D8-048" which is overkill, but I had one lying around from a previous project.
The endcaps can be glued, and/or screwed in place. There are holes in the endcaps already, all you need to do is mark the rod, and drill a 1/16th ish hole for a screw.
Video of it:
https://www.youtube.com/watch?v=QyE_S92_xhk
https://youtu.be/iLL0WrlGMDI
It makes a satisfying clank when assembled and installed.
Requires the purchase of 2-3 springs, a switch, and a 1/2inch rod.
In my build I used Qty 2 of 3" length springs with an approx 8 pound force rating. The Outer diameter of the springs is approx 0.7inch. One of the springs gets cut in half.
The switch is a "V7-2B17D8-048" which is overkill, but I had one lying around from a previous project.
The endcaps can be glued, and/or screwed in place. There are holes in the endcaps already, all you need to do is mark the rod, and drill a 1/16th ish hole for a screw.
ewr2san veröffentlicht auch auf
55 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!