Slicer Discord
Pineapple Springo (Half Size) – Modèle 3D imprimable de MyMiniFactory MyMiniFactory
Puzzles & Games

Pineapple Springo (Half Size)

0 Téléchargements
315 Likes
0 Makes
Voir le modèle
Pineapple springo? Say no more... This is the half-scale version of my Pineapple Springo, part of the Tasty Springos Pack No.1 which you can check out here. I got the best results printing with 3 outlines/shells, 0.15mm layer height, and enough solid top & bottom layers to make the spring part solid infill. No supports required. After printing, carefully separate the coil using a thin spatula, palette knife, butter knife, etc. Work slowly and with caution, especially if you are using sharp tools! *note:* These Springos can be very large and complicated models. Slow computers may struggle with the springo part. There may also be tiny 'holes' that can prompt errors or warnings, but I have sliced these files without issues using Simplify3D and Cura. Results may vary with other slicers. Please share your experiences good and bad so I can continue to improve. Thanks ☺︎   Springos pictured were printed using MatterHackers PRO PLA (Clear, Blonde, Green) and Fillamentum Vertigo Galaxy
Catégorie
Puzzles & Games
Source
MyMiniFactory
Publié
Ce qu'il faut pour imprimer: Débutant Confiance faible
Pourquoi ?
couches de 0.15mm
Monobloc
Supports 1/3
Assemblage 0/3
Réglages 1/3
Taille du plateau 0/3
Post-traitement 0/3
Imprimante
FDM / FFF
Format de fichier
STL
Matériau
PLA
Hauteur de couche
0.15 mm
Logiciel
Cura, PrusaSlicer ou similaire
Pas encore d'évaluations
Pas encore de commentaires – soyez le premier !

Modèles similaires

6 Suggestions
Feed Blog Slicer Calculateur Recherche par image Soumettre Contact Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Ajouter à la collection