Pinecil and Tips Magnet Case

Case for a Pinecil and one tray of tips. The magnets are printed into the model 2-3 layers down. The magnet height is symmetric across the two halves. I sliced my print using Cura and the Pause at Height Post Processing Plugin. The height that I stopped at was 124, you should verify in your slicer software this is the same before printing. You want the pause to happen right before the layer that covers up the magnet. That 124 was based on a .2mm layer height.

The magnets used are .5" x .125", 6x3mm should work too. The pocket is slightly loose and I put a small amount of Loctite 401 or any other super glue at the bottom of the pocket before placing the magnet to avoid rattling and would suggest you do the same.