Pinecil holding collar/grip

This is an add-on for Pinecil soldering iron. You can fit it at the front of the iron to decrease the distance from the tip to grip. It is also possible to slide pinecil's silicone sleeve onto the grip to make it even more "grippy". It fits very tightly so you have to press it firmly. It holds onto plastic case and is also supported by the tip ring. It is possible to exchange the tips without removing the grip. It also has a flat surface on one side so it doubles as a simple stand for the pinecil - the pinecil won't roll and the tip will be quite a bit higher in the air than without the extender.
There is a "bumpy" version that has more grip and a flat version if you prefer that.
I've printed it from pet-g but you can use any filament (pla is not recommended - too low melting point). There is no support required but the part has some 45 degree angles (inside).
I haven't tested it in a situation when you use the iron for extended periods of time with the tip constantly hot (like sev