Thingiverse
Pinecil V2 solder station
von ElliottNurc
4
Downloads
2
Likes
0
Makes
A solder station for my Pinecil V2. Designed to sit in the corner of my desk so i can pull it out whenever I need it.
The solder reel and iron holders need gluing to the base.
To make the holder for my soldering iron I bent some 1.5mm galvanized wire into a shape that would hold my specific tips. I made sure to include a lip/rim I can push against so I can hot-swap between different tips.
all printed in PLA
recommend printing the iron bases in something more heat resistant to delay deforming
MAKE SURE THE IRON HOLDER DOES NOT GET HOT ENOUGH TO WARP THE PLASTIC
The solder reel and iron holders need gluing to the base.
To make the holder for my soldering iron I bent some 1.5mm galvanized wire into a shape that would hold my specific tips. I made sure to include a lip/rim I can push against so I can hot-swap between different tips.
all printed in PLA
recommend printing the iron bases in something more heat resistant to delay deforming
MAKE SURE THE IRON HOLDER DOES NOT GET HOT ENOUGH TO WARP THE PLASTIC
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
