Thingiverse
PinePhone Back Cover
von Remotheman
9
Downloads
11
Likes
1
Makes
Replacement back cover for pinephone with trap door for privacy switches, designed from ground up with FDM print in mind.
Two versions - first with tabs (back2) and second without tabs(back1), tabs are meant to stabilize back cover against warping, but because of how fdm print works- they're no longer needed.
Use PLA for dimensional accuracy. ABS, ASA or any material prone to shrinking is not recommended (read as: will not work).
Attached buttons are not tested - they should be printed in TPU or other semi-flexible material. Redesign will follow shortly.
Trap door can be used as direct 'addon' on top of cover - just use superglue to put it in place (remember to assemble first), should slide freely and protect switches from dust.
Two versions - first with tabs (back2) and second without tabs(back1), tabs are meant to stabilize back cover against warping, but because of how fdm print works- they're no longer needed.
Use PLA for dimensional accuracy. ABS, ASA or any material prone to shrinking is not recommended (read as: will not work).
Attached buttons are not tested - they should be printed in TPU or other semi-flexible material. Redesign will follow shortly.
Trap door can be used as direct 'addon' on top of cover - just use superglue to put it in place (remember to assemble first), should slide freely and protect switches from dust.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!