Thingiverse
Pinewood Derby Trophy
von VeeDubb65
1
Downloads
0
Likes
0
Makes
Simple pinewood derby trophy, inspired by others, but designed from scratch so that two bases fit on a 200x200 build plate.
Each trophy requires 1 base, 2 short, and 1 tall. If your printer is calibrated right, the posts should press fit without glue. If it's not calibrated well (or at least not calibrated similarly to mine) you might need to sand the ends of the posts or use a spot of glue.
Print the posts laying flat for better strength.
Each trophy requires 1 base, 2 short, and 1 tall. If your printer is calibrated right, the posts should press fit without glue. If it's not calibrated well (or at least not calibrated similarly to mine) you might need to sand the ends of the posts or use a spot of glue.
Print the posts laying flat for better strength.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
