Thingiverse
Pingable Remote Device
von FINNBOBTHEGREAT
0
Downloads
0
Likes
0
Makes
This is a small networking device that allows you to configure an IP Address and Subnet Mask, then plug into your network and you can ping this device from a remote location using a PC.
The device has uses a Waveshare RP2040-ETH board to handle the ethernet connection, drive the OLED display, handle the button presses and reprogram the boards IP and Subnet.
It has a 400 mAh battery and is charged using a TP4056 Battery charger.
The RP2040-ETH only has a 10Mb connection speed, so will not be able to connect to a switch or PC that cannot handle a 10Mb connection.
Future Upgrades:
- 100Mb Connection speed
- Device that can ping as well as be pinged
- Improve 3D prints to fit flush without Blue Tack filler
The device has uses a Waveshare RP2040-ETH board to handle the ethernet connection, drive the OLED display, handle the button presses and reprogram the boards IP and Subnet.
It has a 400 mAh battery and is charged using a TP4056 Battery charger.
The RP2040-ETH only has a 10Mb connection speed, so will not be able to connect to a switch or PC that cannot handle a 10Mb connection.
Future Upgrades:
- 100Mb Connection speed
- Device that can ping as well as be pinged
- Improve 3D prints to fit flush without Blue Tack filler
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
