Thingiverse
Pinned Hinge
por Littlenuts
2
Descargas
5
Likes
0
Makes
Plenty of RC hinges on here but most were not symmetrical so I though I would print one modeled after a popular brand.
This is best printed standing on it's edge, and with supports. Takes a piece of 0.7-0.8mm piece of piano wire as the hinge pin (or a cut off T pin). Worked well. Only post processing was to clean the holes with a 1mm drill. It is symmetric so just print two and assemble.
This is best printed standing on it's edge, and with supports. Takes a piece of 0.7-0.8mm piece of piano wire as the hinge pin (or a cut off T pin). Worked well. Only post processing was to clean the holes with a 1mm drill. It is symmetric so just print two and assemble.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!