Pinocchio (HueForge)

Pinocchio (20x20 HueForge)I found this Pinocchio picture on Pinterest, unfortunately without any further information about the original creator. It was printed with a 0.2 needle on a P1S, could possibly be adapted to a 0.4 needle, but I haven't tested that. Print Instruction:Print at 100% infill with a layer height of 0.04mm with a base layer of 0.16mmThe Model is 200x200mm in sizeYou may print at higher layer heights below the Min Depth of 0.48mmThe Max Depth is 2.2mm and the Actual Depth is 2.2mm Filaments Used: PLA eSun Matte Deep Black Transmission Distance: 0.1 PLA Sunlu PLA+ 2 Red Transmission Distance: 6 PLA BambuLab Matte Marine Blue Transmission Distance: 0.5 PLA eSun PLA+ Yellow Transmission Distance: 6 PLA BambuLab Basic Jade White Transmission Distance: 5 Swap Instructions: Start with Matte Deep Black At layer #10 (0.52mm) swap to PLA+ 2 Red At layer #15 (0.72mm) swap to Marine Blue At layer #19 (0.88mm) swap to PLA+ Yellow At layer #34 (1.48mm) swap to Jade White for t