Thingiverse
Pinsentry Holder
von SalamanderLime
0
Downloads
0
Likes
0
Makes
A basic holder for a Barclays PINsentry. Can be fixed to a wall or perhaps under a unit, has two holes for screws, drawing pins etc.
Shouldn't need any support. Might need a brim if you're concerned about the base warping, but seemed fine when I printed it out.
Shouldn't need any support. Might need a brim if you're concerned about the base warping, but seemed fine when I printed it out.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!