PIP Magnetic Cable/Wire Guide/Keeper

A simple print-in-place cable/wire guide/keeper. Keeps up to five wires in place of various sizes. A magnet on the back allows for placement on metal desk surfaces without the sticky materials that never hold long enough or strong enough.

This print-in-place design results in a hinged assembly that opens to ninety-degrees for wire placement. Close the keeper and use the clip to snap tightly and securely shut allowing for future opening and repositioning if needed. Magnet allows for easy adjustments and secure mounting.

This design is made for a 20mm x 3mm neodymium magnet for the best secure mounting. An 18mm x 3mm magnet can also be used for a good secure mount. Both of these types are easily purchased on-line. I used a clear hard-bond adhesive (Gorilla-Glue Clear-Grip(r) or E6000(r) and let cure for 24 hours) to set these magnets strongly into the recess.

I have included both the STL and GCODE files here for your use. The GCODE is pre-set for my Ender 5-Plus Pro so may or may not