Back
Pipe Dock – 3D printable model from MakerWorld MakerWorld
Other Toys & Games

Pipe Dock

25 Downloads
10 Likes
13 Makes
Download Model
This was molded around the actual switch with an airgap on the sides so it does not scratch your screen by pushing too tight.Like always there is a slot in the back for a female to male usbc cable to pass through to connect to your dock or minindock.You will want to use a 90 degree cable i used this one to when designing ithttps://www.amazon.com/dp/B07QYRB1YW?ref=ppx_pop_mob_ap_shareThis producs is not licensed or endorsed by nintendoI accept no responsibility in the unlikely event this product
Category
Other Toys & Games
Source
MakerWorld
Published
07.10.2023
Updated
14.02.2026
Comments
0

Comments

No comments yet – be the first!
More Other Toys & Games Models All MakerWorld Models More by scott.olson92

Similar Models

6 Suggestions

Add to Collection