Thingiverse
Pipe end cap 20mm ID
von OSINdesigns
2
Downloads
3
Likes
0
Makes
Pipe end cap 20mm - Internal diameter
Used for cheap hollow barbell
Fits quite loose so probably would recommend up scaling by +/- 1% or wrapping with some Teflon tape.
Printed with no supports just fine
Used for cheap hollow barbell
Fits quite loose so probably would recommend up scaling by +/- 1% or wrapping with some Teflon tape.
Printed with no supports just fine
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
