Pipe Junction Box for Low Voltage Electrical

Print the junction box from PETG, ABS, or other outdoor stable filament. Print at 100% infill, with supports. Print the grommet from TPU at 100% infill, with supports. Install the grommet into the end of the junction box, then thread your ethernet through. The grommet supplied has a 6mm hole which works perfectly with the 6.2mm Cat6 cabling I needed this for. Follow your local regulations. Mine says I can use this for low voltage wiring, but anything else would be a gray area at best. Install the junction box on the wall using the 3 holes to screw it down. Be sure to put some outdoor caulk or other outdoor rated sealant under the flange before screwing it down to prevent water ingress. I was installing a wireless bridge, and needed some way to get a single Cat6 cable in through the wall of my barn (the bridge is PoE, so only one cable needed). The existing methods available at the big box stores all seemed like massive overkill for what I actually needed, which was simply a way to prot