Slicer Discord
Piper Camera Mount – 3D-Druckmodell von Thingiverse Thingiverse

Piper Camera Mount

von robmink
5 Downloads
2 Likes
0 Makes
Zum Modell
This is a webcam mount for a Piper printer or any other 1/2 EMT conduit you wish to put a camera on. To build, print the mount top on the flanges to bolt, with the camera part facing up, and the bottom on its side. No supports needed. For the camera, remove the rubber cover over the screw on the back, then unscrew and drive the pin out. If you wish to use this to view your heads, for example you wish to view repeat-ability or offset between nozzles, you can pop the cover off, remove the 3 screws, and gently rotate the lens to change the focus point. Use a long M3 screw to secure the camera to the top, and m3 screws and nuts to hold the top and bottom together.

Thanks for looking!
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

robmink veröffentlicht auch auf

1 zusätzliche Modelle auf 1 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen