Thingiverse
PIR_sensor_Box HC-SR501
von J-M_D
35
Downloads
20
Likes
0
Makes
for HC-SR501
PIR sensor Box for Arduino etc.
Version 2:
-If you want to have the holes for PIR adjustment, print this part with a 0.4mm nozzle.
-If you don't want the holes: 0.3mm nozzle.
4 holes to pass the wires are pre-drilled, just a screwdriver to finish it.
PIR sensor Box for Arduino etc.
Version 2:
-If you want to have the holes for PIR adjustment, print this part with a 0.4mm nozzle.
-If you don't want the holes: 0.3mm nozzle.
4 holes to pass the wires are pre-drilled, just a screwdriver to finish it.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
