Pirate HueForge

Picture source - author: NotAn ArtManThen used HueForge v0.8.1 to create the model. Just black and white. If you use a white with a TD lower than 6, it will have less detail![TD =Transmission Distance is a measure of how much light filament lets through. Low TD = the filament is not transparent, high TD is the opposite ;) ] Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm. Model size is 200x120mm. You can only modify the X and Y dimensions. Do not adjust the height (Z) in your slicer! The layers would not be correct. You may print at higher layer heights below the Min Depth of 0.56mm. The Max Depth is 1.8mm and the Actual Depth is 1.8mm It is possible to print without AMS by manually changing the filament (setting filament change or pause) in the slicer, depending on your printer and sw support. These were my settings and colors for my print that you see in the picture. Your results may be depending on the filament you use.Filaments Used: PLA Elegoo+ Black