MakerWorld
Vehicles
Model downloaden
Pivot Cycles Hitch Cover
10
Downloads
3
Likes
8
Makes
I utilized the blank hitch cover published by grizzie17 and added the Cannondale logo. This hitch will fit a 2" x 2" receiver and will need a bolt to hold it into place. grizzie17 has designed one that works pretty well, though it rattles a bit since it's not a perfectly snug fit. That model can be found at the following link: https://makerworld.com/en/models/212385#profileId-910085 It is recommended to add a brim of no less than 5mm inside and outside when printing this.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
