Pixel 3a Case

**UPDATE 5-29-19 - Beta 5:**

Started nearly from scratch on the 3a cutout, as I wasn't satisfied with the prints I was getting with the previous one, or the final one using the SCAD design. I don't know if compiling out just the shell slightly changed the sizes or what, but every print I made with the stock SCAD shell was far too large. I finally remeasured the phone, sized everything to about ~1.4mm larger than the phone shell, and got a winner. The beta 5 case fits nearly flush with the device with no play. it is essential you remove any excess material/defects from inside the shell as it will prevent the device from fitting and may crack the case. I still plan to tweak the design a bit more before moving on to cutting/gluing the folio cover on (I still don't like the power/volume button area, and the camera/fingerprint cutouts are about 0.4mm off center. I'm guessing about 1-2 more design iterations before a "final" version (both with the area where the folio cover will glue in,