Thingiverse
Pixel 4A Case
door M_Heffler
37
Downloads
25
Likes
0
Makes
This file is the actual size. I needed to scale it up about an mm to have it fit well with a TPA A85 filament. Some trimming is required around the USB-C port and the headphone jack, but this is easily done with your filament snips in the flexible filament.
I used a 1 mm nozzle, o.4mm layer height and 1mm line width and it printed in about an hour on my CR20 Pro! i found a few Brim lines worked well for bead adhesion.
I designed it in Fusion 360 from measurements off my phone.
I used a 1 mm nozzle, o.4mm layer height and 1mm line width and it printed in about an hour on my CR20 Pro! i found a few Brim lines worked well for bead adhesion.
I designed it in Fusion 360 from measurements off my phone.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
