Pixel 8 Juggernaut Case (compatible with medium mount)

Juggernaut doesn't make cases for pixel cases so I made this one. One of the key challenges was the location of the volume down button, which is right where you would want the mount to latch onto (otherwise the phone would be way off to the side when mounted). To overcome this I made a simple button redirect located on the top panel. For consistency, all 3 buttons were designed in the same way.

Printing tips:
- I recommend using PETG
- Buttons and bezel: support not required. I found that the buttons are best printed face down (i.e. the face with the circle or triangle design adhering to the plate, preferably with a raft).
- Case top and bottom: needs support. Recommend 0.16mm layer height, settings favoring strength (e.g. 25% infill, 6 layer walls, etc).

Assembly:
- Glue/epoxy bezel to corresponding impressions on top and bottom of case.
- Buttons are inserted from the top through the corresponding holes in the case, carefully snaking the redirect mechanism in first, oriented such