Thingiverse
Pixel Art Building Blocks
door 3D-mon
1.3k
Downloads
1.2k
Likes
3
Makes
This is a set of models which you can use to create any kind of pixel art you like
Everything prints without supports and the pixels print without infill to save material and print time. That also makes it possible to light up the art from behind.
The bevel on the top is so there aren’t inconsistent gaps caused by irregular first layer calibration and to accentuate the pixelated look.
Simply print as many pixels as you want and join them with 3D printed clips. Mostly you’ll want side clips, but sometimes you might need a corner clip. Flip it over and you’re done.
One hour of print time will make 17 pixel blocks. You can fit 72 pixels on a Prusa MK3 3D printer.
SIZE
At 100% scale, the cubes are 2 cm wide. You can make them smaller or bigger as you like, but you’ll have to scale the clips to be shorter (keeping the gap the same size) if you go below 13 mm cube size. The corner pieces will need scaling as well, you can try using the same percentage scale on them as the cub
Everything prints without supports and the pixels print without infill to save material and print time. That also makes it possible to light up the art from behind.
The bevel on the top is so there aren’t inconsistent gaps caused by irregular first layer calibration and to accentuate the pixelated look.
Simply print as many pixels as you want and join them with 3D printed clips. Mostly you’ll want side clips, but sometimes you might need a corner clip. Flip it over and you’re done.
One hour of print time will make 17 pixel blocks. You can fit 72 pixels on a Prusa MK3 3D printer.
SIZE
At 100% scale, the cubes are 2 cm wide. You can make them smaller or bigger as you like, but you’ll have to scale the clips to be shorter (keeping the gap the same size) if you go below 13 mm cube size. The corner pieces will need scaling as well, you can try using the same percentage scale on them as the cub
3D-mon publiceert ook op
203 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!