Pixel art (Red panda)

So this is my simple and quickly printable solution to make pixel art IRL!
To connect all this part together I used a lot of toothpicks. My first problem that occurred when I ran out of the first type of toothpicks and the one I bought later had a little bigger diameter.
That's why before u print a lot of them just print one of a 2way kind and test if your toothpicks fit well.

When assembling keep track of spacing between connectors. Use smth as a spacer I used a 2x1 lego block but anything will work. Also if you're looking forward to using bottle caps like I did put some on and check the spacing once again and see if it matches your expectations

Enjoy