Thingiverse
Pixel Strip to Wall Mount
by PHOENlX
19
Downloads
9
Likes
0
Makes
This is a 3D printed Pixel Strip holder that can be mounted to a flat surface for Christmas Lights. This mount will hold the pixel strip approximately 2.5" (63.5mm) from the surface they are mounted to. This was designed for the HolidayCoro PixNode Classic Strip and Boscoyo ORIGINAL 12mm Pixel/RGB Mounting Strips. There are two variations available. The standard version and a zip tie channel version. The zip tie channel version will require the use of supports.
[Pixel Strip to Wall Mount](https://www.thingiverse.com/thing:4938231)
[Pixel Strip to Wall Mount With Zip Tie Channel](https://www.thingiverse.com/thing:4938232)
Have a suggestion for a mounting clip? Don't be afraid to contact us on our Facebook page, or send us a message here!
www.facebook.com/siskfamilylightshows
Like my designs? Help support us by donating to our show!
Thanks for looking at and supporting my designs!
[Pixel Strip to Wall Mount](https://www.thingiverse.com/thing:4938231)
[Pixel Strip to Wall Mount With Zip Tie Channel](https://www.thingiverse.com/thing:4938232)
Have a suggestion for a mounting clip? Don't be afraid to contact us on our Facebook page, or send us a message here!
www.facebook.com/siskfamilylightshows
Like my designs? Help support us by donating to our show!
Thanks for looking at and supporting my designs!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
