Thingiverse
Pixel Tablet Magnetic Wall Mount without using USB-C
von jaymathu91091
1
Downloads
6
Likes
0
Makes
Created this model to mount a Pixel tablet for Home Assistant. Wanted something that looked clean but also useful. This model uses 10 1" magnets and some Pogo Pins from Digikey
Power is done via a PoE to 12v adapter
The two holes in the middle are to fit into a standard 1 gange electrical box ( I couldnt get it to lay flat enough to the wall with that, so ended up using the 4 screws into the drywall.
Printed with Bambu X1
https://a.co/d/41uvrcq
https://www.digikey.com/short/vz00rrcr
Power is done via a PoE to 12v adapter
The two holes in the middle are to fit into a standard 1 gange electrical box ( I couldnt get it to lay flat enough to the wall with that, so ended up using the 4 screws into the drywall.
Printed with Bambu X1
https://a.co/d/41uvrcq
https://www.digikey.com/short/vz00rrcr
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!