Pixel Tester Box

Basically this is a work in progress. It's a way to test either 2801 or 2811 pixels to see which pixel is bad. It's always the one acting up or the one before it when one goes bad. This box uses needles that pierce the jacket of the pixel wire in order to tap into the data signal. It's set up to be able to tap ground, data, clock. It uses a 9V battery for power. However, it could use a lipo or other power source depending on what you have and the voltage of your pixels. Since this box supplies it's own power, you just rely on the data signal wires. So you can use this box to test 5V and 12V pixels once it's set up. I am going to be using a slide switch for powering the box On/Off. I am then using a three position DPDT micro switch to choose between 2801 and 2811 pixels. The switch will allow me to move the third pin to have nothing on it or clock. Reason being is that in a 2811 pixel the voltage wire WILL BE TAPPED into. Using a switch ensures it's dead or again, has clock