Pixel Tester Clamp

Basically a way to find out if the first acting up pixel is the problem or the pixel prior is the problem. To put this together you will need 1 #6 pan head screw and 4 needles/stick pins. Heat the stick pins up and push them through the slots so that the needle point sticks up enough to be able to press through the wire jacket of your pixels. Then use some bullet connectors and crimp onto the needle. This way you can use different 2811 pixels and just plug/unplug the one you are testing. If you heat up the needle you won't be able to solder wire to it, at least I couldn't. So if you want to solder keep that in mind. When testing test between the first pixel giving an issue and the one prior. Separate the wires and place them into the grooves. Close the top and press so the needles stick into the wire jacket. If the pixel lights and acts normal, the bad pixel is the one past where you are testing. If the test pixels acts up, its the pixel prior. I am going to try and do some