Thingiverse
Pixhawk Cube Everycopter adapter
von cjdavies
7
Downloads
5
Likes
0
Makes
This mount bolts through some of the arm mounting holes, rather than the 30.5mm pattern holes, in case you block access to the 30.5mm holes by placing a PDB inside the frame. Using this mount you can attach your PDB to the bottom plate, assemble top & bottom plates with the PDB inside, then insert your hexdriver through the bottom plate to access the bolts to attach the Pixhawk Cube.
Requires the same four M3 threaded brass heat set inserts.
Requires the same four M3 threaded brass heat set inserts.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
