Pixhawk Safety Switch Mount

This is for mounting the dreadful Pixhawk arming switch. I designed this to install by drilling a hole in the plate you plan on mounting it to so the switch can fully pass through it (maybe 14mm?), then this mounts the switch. I designed this to fit on my frame's gps pedestal holes pre-drilled into my top plate. Hopefully it can fit yours, if not I can resize it for a larger X-configuration.

There are three versions, I recommend either v2 verision.

v1: standard mount with a non-flat bottom. Designed this for my specific frame (ZD850)
v2: Same non-flat bottom, but has the screw holes extended upward to hide the remaining threads on the screw.
v2 flat: This is the same design to hide the screw threads, but with a flat bottom. Easier to print for most and should do the job.