PiZero Multi Box

Sliding Base (Blue): - Print 1
--------------------------------------
* Printed PLA 0.16mm, 15% infill, without Supports.
* Has been Design with counter sunk 4mm holes for mounting and still allowing the main Box to slide on.
* It has a tight tolerance to hold the PiZero Box Closed.

Main PiZero Box (Grey): - Print 1
--------------------------------------------
* Printed PLA 0.16mm, 15% infill, with Supports only for side wall thru-holes.
* Designed so the PiZero can be directly inserted (No SD Card!!) with or without IO/Vid/Run Pins
* Run Led can be seen via a view hole from the top of the PiZero Box or from any angle by inserting a short piece of clear 1.75mm filament to act as a light conductor (May need enlarging, But a tight fit)
* Has Access to Needed Sockets and Pins, with small room at the bottom of the PiZero board for an added USB Cable or Plug (But has not been test)

Corner Supports (Red): - Print 4
------------------------------------------
* Printed PLA 0.1