Thingiverse
PL-259 Cover
door JetFixxxer
1
Downloads
1
Likes
0
Makes
I made this for my antenna feed line. The file is named SO239, but it's for PL-259
Use a couple of tie wraps (zipties), you can also use some silicon to glue the shells together. I also wrapped it with self fusion tape or marine shrink tube which can be found Amazon.
ID is a little big if you want to use self fusion tape on the connector before you put the cover/protector on.
You can adjust the height in the slicer. Make sure you un-tick uniform scale.
I used PETG.
Use a couple of tie wraps (zipties), you can also use some silicon to glue the shells together. I also wrapped it with self fusion tape or marine shrink tube which can be found Amazon.
ID is a little big if you want to use self fusion tape on the connector before you put the cover/protector on.
You can adjust the height in the slicer. Make sure you un-tick uniform scale.
I used PETG.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
